QA QC Inspector /Engineer

1/2014 – offen

-Secure that external Quality requirement are incorporated into FMC Quality system / project execution process
-Participating and give input to Pre-Production, clarification, Kick-off and Status Meetings with Customers and internal managers as required
-Review of the SDRL, BOM, FAT, MRB Index, and MRB Final dossier submitted by the supplier according to the project requirements.
-MPQP, Quality Plan and ITP based on the work scope.
-Reviewing Material/ Loading Certificates, WPQs, MRB
-Qualifying the suppliers based on NORSOK M-650 / Client Requirements.
-Witness and verify FAT of Mechanical equipment in accordance to QC described in ITP.
-Understanding the contract scope/ statement of work, customer specification and participate in planning and control w.r.t project milestones.
-Verification of technical documentation supplied for Approved Vendor List (AVL)
-Coordinate the need for new Service DRL`s together with Engineering.
-Perform and/or participate in Internal and Customer Audits.
-Register and Facilitate Follow-up of Customer Issues and internal QN reports
-Assist the project to create Deviation/Concession Requests
-Perform/Facilitate RCA (Root cause failure analysis) when required
-Participate and follow up Hold and Witness Points (Internal and Supplier) where requested in accordance to approved ITP
-Perform Quality Inspections/Verifications Onshore and Offshore where required

Total-Quality-Management

7/2013 – 12/2013

•Inspection of materials as per EN/ISO, ASTM/ASME, NORSOK standards and client specifications for Seamless and welded pipes (stainless steel, steel, boiler tubes, steel pipes / line pipes and elbows, tees, reducers, bends, caps/ heads, flanges(Weld-neck, Blind, Threaded, Flat face, Lap-joint, Orifice, Slip-on, Socket) and bolts/Gaskets).
•Inspection of raw materials of (Seamless & welded) Pipes, Fittings, and Plates, Structural materials and verify mill test certificates, visual Inspections, dimensional check & condition of materials and Inspection of inward materials
•Verification of calibration certificates and Verification of material test certificates for incoming materials & Coordinating with Material Controller
•Coordination with third party inspection agencies for Positive Material Identification (PMI) for Stainless Steel and Alloy Steel and Hardness Testing and ASME II section A, B & C for raw materials.
•Perform UT of plates for lamination Ultrasonic Flaw detection of pipe BUTT welds, Visual Inspection, MT & PT of welds, Dimensional inspection, and Final documentation.
•Compiling report for material records and documentation.
•Material control management and for ensuring of traceability of material certificates and of NDT control

Qualitätsprüfung