Electronic Engineer (Hardware Designer)

8/2020 – offen

• Hardware Design and Product Development
- Analysis of customer and system requirements
- PCB designing on Altium Designer and performing simulation of circuit analysis
- Benchmarking of electronic components in terms of availability, cost and specifications
• Certification and Product Compliance
- Conducting a preliminary study for EMC testing
- Perform pre-certification testing of EMC compliant product
- Circuit design and spark ignition calculation specifically for Atex environment.

Altium Designer

3/2019 – 4/2020

• System Architecture Responsibilities.
- Analysis of customer and system requirements.
- Creation of test specification considering the requirements from OEM’s.
- Did feasibility study and review of the PCB Drawings, layout, BOM and its schematic.
- Benchmarking of the electronic components (e.g. Mosfets, ADC).
- Investigation of the mosfet slew rate, try to reduce it under the consideration of EMC boundaries.
• Software Development and Testing.
- Experienced in SPI, UART, CAN, I2C protocol and CAN related tools.
- Better knowledge in Embedded Systems & C programming.
- Diagnose hardware and software failures testing and made report out of it.
- Debug and fix the software issues.
- Perform testing on Arduino Atmega board, did coding of C++ language and cross check the accuracy of the external temperature sensor according to its datasheet.
• Hardware Development and Testing.
- Good understanding of Hardware Development and PCB designing (both analog and digital).
- Sound knowledge of power electronics and strong handling of Oscilloscope, soldering and fault diagnostic.
- Did simulation of circuit analysis as well as validation of hardware design and made prototyping out of it.
- Performed worst-case analysis of hardware design according to ISO 26262.

Altium Designer, C++, Canoe Software, Labview